Leading Authorized Wholesale Dealer of tl082cdr smd ic, max232idr smd ic texas soic, ca3140 smd ic intersil / renesas soic package, 74hc541pw, sg3525 smd ic and 2n3053 npn transistor cdil to-39 from Mumbai.
Operational Amplifiers - Op Amps Dual Gen Purp JFET
Low Power Consumption Wide Common-Mode and Differential Voltage Ranges Low Input Bias and Offset Currents Output Short-Circuit Protection Low Total Harmonic Distortion . . . 0.003% Typ
Meets or Exceeds TIA/EIA-232-F and ITU Recommendation V.28 Operates From a Single 5-V Power Supply With 1.0-F Charge-Pump Capacitors Operates Up To 120 kbit/s Two Drivers and Two Receivers ±30-V Input Levels Low Supply Current . . . 8 mA Typical ESD Protection Exceeds JESD 22 − 2000-V Human-Body Model (A114-A) Upgrade With Improved ESD (15-kV HBM) and 0.1-F Charge-Pump Capacitors is Available With the MAX202 Applications − TIA/EIA-232-F, Battery-Powered Systems, Terminals, Modems, and Computers
4.5MHz, BiMOS Operational Amplifier with MOSFET Input/Bipolar Output
Features• MOSFET Input Stage- Very High Input Impedance (ZIN) -1.5T (Typ)- Very Low Input Current (Il) -10pA (Typ) at 15V- Wide Common Mode Input Voltage Range (VlCR) - Can beSwung 0.5V Below Negative Supply Voltage Rail- Output Swing Complements Input Common ModeRange• Directly Replaces Industry Type 741 in Most Applications• Pb-Free Plus Anneal Available (RoHS Compliant)Applications• Ground-Referenced Single Supply Amplifiers inAutomobile and Portable Instrumentation• Sample and Hold Amplifiers• Long Duration Timers/Multivibrators(seconds-Minutes-Hours)• Photocurrent Instrumentation• Peak Detectors• Active Filters• Comparators• Interface in 5V TTL Systems and Other LowSupply Voltage Systems• All Standard Operational Amplifier Applications• Function Generators• Tone Controls• Power Supplies• Portable Instruments• Intrusion Alarm Systems
Component Disposal Instructions 1. CDIL Semiconductor Devices are RoHS compliant, customers are requested to please dispose as per prevailing Environmental Legislation of their Country. 2. In Europe, please dispose as per EU Directive 2002/96/EC on Waste Electrical and Electronic Equipment (WEEE).
Switching Voltage Regulators 150 KHZ 3A STEP-DOWN VLTG REG
Features 3.3V, 5V, 12V, and adjustable output versions Adjustable version output voltage range, 1.2V to 37V± 4% max over line and load conditions Guaranteed 3A output load current Input voltage range up to 40V Requires only 4 external components Excellent line and load regulation specifications 150kHz fixed frequency internal oscillator TTL shutdown capability Low power standby mode, IQ typically 100A Thermal shutdown and current limit protection
Features The plastic package carries Underwriters Laboratory Flammability Classification 94V-0 Idea for printed circuit board Glass passivated Junction chip Low reverse leakage High forward surge current capability High temperature soldering guaranteed 250 °C/10 seconds at terminals
Request Callback
Yes! I am interested
CDIL 1N5408 General Purpose Plastic Rectifiers (3A)
1. The plastic package carries Underwriters Laboratory Flammability Classification 94V-0 2. Construction utilizes void-free molded plastic technique 3. Low reverse leakage 4. High Forward surge current capability 5. This product is available in AEC-Q101 Compliant and PPAP Capable also.
The 7805 voltage regulator is a popular three-terminal linear regulator known for providing a fixed, stable +5V DC output from a higher, unregulated input voltage. Key specifications include a wide input voltage range (typically 7V to 35V) and a maximum output current of up to 1.5A.
The 7805 is a three-pin device in its most common packages (like the TO-220). The pins are configured as follows: Pin 1 (Input): Connects to the unregulated positive DC input voltage source.Pin 2 (Ground): The common ground reference for both the input and output (often connected to the metal tab on the TO-220 package).Pin 3 (Output): Provides the regulated +5V DC output.
The 1N4007 is a widely used 1A, 1000V general-purpose silicon rectifier diode in a DO-41 package. It converts AC to DC, handles up to 30A surge current, and features low leakage. It is ideal for power supplies, freewheeling, and reverse polarity protection. It is part of the 1N400x series.
FEATURE: 1. This product is available in AEC-Q101 Qualified and PPAP Capable also.
Note: For AEC-Q101 qualified products, please use suffix -AQ in the part number while ordering.
APPLICATION: These Axial Lead Mounted Rectifiers are used for General-Purpose Low-Power
Features�� Wide 5V to 40V Input Voltage Range�� Positive or Negative Output VoltageProgramming with a Single Feedback Pin�� Current Mode Control Provides ExcellentTransient Response�� 1.25V reference adjustable version�� Fixed 180KHz Switching Frequency�� Maximum 5A Switching Current�� SW PIN Built in Over Voltage Protection�� Excellent line and load regulation�� EN PIN TTL shutdown capability�� Internal Optimize Power MOSFET�� High efficiency up to 94%�� Built in Frequency Compensation�� Built in Soft-Start Function�� Built in Thermal Shutdown Function�� Built in Current Limit Function�� Available in TO263-5L package
NPN Epitaxial Planar Silicon High Voltage Transistor
FEATURE: 1. This product is available in AEC-Q101 Compliant and PPAP Capable also. Note: For AEC-Q101 compliant products, please use suffix -AQ in the part number while ordering.
APPLICATION: 1. High Voltage NPN Transistor For General Purpose And Telephony Applications
FEATURE: 1. Output current up to 1A 2. Few external components and high flexibility 3. Internal thermal and overload protection 4. Output transistor safe-area compensation 5. Internal short circuit current limiting 6. Package: CL7805DT : TO-252
TBD62083AFWG is a DMOS transistor array designed as a high-current, high-voltage low-side driver. It functions similarly to a Darlington array (like ULN2803) but uses DMOS outputs for improved efficiency and lower saturation voltage.
Request Callback
Yes! I am interested
BAV99 SILICON PLANAR HIGH SPEED SWITCHING DUAL DIODE CDIL SOT23
FEATURES• Peak power dissipation 600W @ 10 x 1000 μs pulse• Low profile package• Excellent clamping capability• Glass passivated junction• IEC 61000-4-2 ESD 30KV(Air), 30KV(Contact)• ESD protection of data lines in accordance with IEC 61000-4-2• EFT protection of data lines in accordance with IEC 61000-4-2
FEATURE: 1. NPN Complements to BCX54,BCX55,BCX56 2. Low Voltage 3. High Current 4. This product is available in AEC-Q101 Qualified and PPAP Capable also. Note: For AEC-Q101 qualified products, please use suffix -AQ in the part number while ordering.
These Axial Lead Mounted Rectifiers are used for General-Purpose Low-Power Applications
FEATURE: 1. This product is available in AEC-Q101 Qualified and PPAP Capable also. Note: For AEC-Q101 qualified products, please use suffix -AQ in the part number while ordering
