SMD IC's

Product Details:

Low Power Consumption

Wide Common-Mode and Differential Voltage Ranges

Low Input Bias and Offset Currents

Output Short-Circuit Protection

Low Total Harmonic Distortion . . . 0.003% Typ

High Input Impedance . . . JFET-Input Stage

Latch-Up-Free Operation

High Slew Rate . . . 13 V/µs Typ

Common-Mode Input Voltage Range Includes VCC+

Additional Information:

• Delivery Time: IMMEDIATE

Product Details:

Features • Floating channel designed for bootstrap operation Fully operational to +600V Tolerant to negative transient voltage dV/dt immune • Gate drive supply range from 10 to 20V • Undervoltage lockout • 3.3V, 5V and 15V input logic compatible • Cross-conduction prevention logic • Internally set deadtime • High side output in phase with input • Shut down input turns off both channels • Matched propagation delay for both channels • Also available LEAD-FREE

Product Details:

description/ordering informationThe LMV321, LMV358, and LMV324/LMV324Sare single, dual, and quad low-voltage (2.7 V to5.5 V), operational amplifiers with rail-to-railoutput swing. The LMV324S, which is a variationof the standard LMV324, includes a power-savingshutdown feature that reduces supply current to amaximum of 5 μA per channel when the amplifiersare not needed. Channels 1 and 2 together are putin shutdown, as are channels 3 and 4. While inshutdown, the outputs actively are pulled low.The LMV321, LMV358, LMV324, and LMV324Sare the most cost-effective solutions forapplications where low-voltage operation, spacesaving, and low cost are needed. These amplifierswere designed specifically for low-voltage (2.7 Vto 5 V) operation, with performance specificationsmeeting or exceeding the LM358 and LM324devices that operate from 5 V to 30 V. Additionalfeatures of the LMV3xx devices are acommon-mode input voltage range that includesground, 1-MHz unity-gain bandwidth, and 1-V/μsslew rate.The LMV321 is available in the ultra-small DCK(SC-70) package, which is approximatelyone-half the size of the DBV (SOT-23) package.This package saves space on printed circuitboards and enables the design of small portableelectronic devices. It also allows the designer toplace the device closer to the signal source toreduce noise pickup and increase signal integrity.

Product Details:

OCTAL BUFFERS AND LINE DRIVERSWITH 3-STATE OUTPUTS

Operating Voltage Range of 4.5 V to 5.5 V
High-Current 3-State Outputs InterfaceDirectly With System Bus or Can Drive UpTo 15 LSTTL Loads
Low Power Consumption, 80-μA Max ICC
Typical tpd = 12 ns
±6-mA Output Drive at 5 V
Low Input Current of 1 μA Max
Inputs Are TTL-Voltage Compatible
Data Flow-Through Pinout (All Inputs onOpposite Side From Outputs)